Skip to content
Rules & Rego

Exhaust Noise Limits in Australia by State

90 dB(A) isn't the limit for every car. Here's how stationary noise limits work by build date, the ADR 83 plus 5 dB(A) rule, and what each state does about loud exhausts.

7 min readUpdated 3 November 2026Horsepower House
Exhaust Noise Limits in Australia by State
In this guide

"90 decibels" gets thrown around like it's the limit for everything. It isn't. Your legal limit depends on when the car was built and whether it was certified to ADR 83/00, and for a lot of modern performance cars the real number is lower than you'd expect.

Here's how the limits work, how the test is done, and what each state does when your exhaust gets noticed.

Quick answer: Stationary limits are 96 dB(A) for older cars, 90 dB(A) for cars from the early 1980s on, and for ADR 83/00 cars, no more than 5 dB(A) above the stationary level published for that model. Look yours up on the Green Vehicle Guide. Keep the cats. Fail a test and you're looking at a defect notice and a fine.

The three limits that matter

In-service noise limits come from state environment protection laws, aligned to the national Australian Design Rule framework. In practice they fall into three groups for passenger cars.

Older cars: 96 dB(A)

Cars built before the early 1980s cut-off have a 96 dB(A) stationary limit. The cut-off date differs slightly between states:

  • NSW EPA: built before 1 January 1983
  • EPA Victoria: manufactured before 1 November 1983

Pre-ADR 83 cars from the 1980s on: 90 dB(A)

Cars built after that cut-off but not certified to ADR 83/00 have a 90 dB(A) limit.

ADR 83/00 cars: signature level plus 5 dB(A)

ADR 83/00 applies to vehicles from around 2005 onward. Manufacturers run a stationary test and report the result, known as the vehicle's "signature" noise level. In service, the car can't exceed that level by more than a tolerance set by each state. NSW and Victoria both use 5 dB(A), and Queensland's transport minister has confirmed Queensland's regulation allows the same 5 dB tolerance.

In NSW, ADR 83 vehicles with a compliance plate on or before 1 September 2011 use whichever is higher: the older fixed limit or signature plus 5 dB(A). After that date it's signature plus 5 dB(A).

The catch: your limit is only as high as your car's signature level allows. If that level is in the low 80s, plus five puts your limit below 90, and a "90 dB(A) legal" exhaust can still fail.

How to find your number

The federal Green Vehicle Guide lists stationary signature noise for light four-wheeled vehicles. If your car isn't there, the Department of Infrastructure publishes a supplementary spreadsheet from the Road Vehicle Certification System data. If a car appears in both, the Green Vehicle Guide figure wins.

One Victorian wrinkle worth knowing: EPA Victoria states that if an owner modifies the exhaust on an ADR 83/00 vehicle, "it is no longer regarded as being certified with ADR 83/00". If you've changed the exhaust on a late-model car in Victoria, confirm with EPA Victoria which limit it'll be tested against.

Motorcycles

For completeness:

  • NSW: road bikes built on or after 1 March 1984 are 94 dB(A); others 100 dB(A)
  • Victoria: before 1 March 1985 is 100 dB(A); on or after is 94 dB(A)
  • ADR 83/00 bikes use the same plus 5 dB(A) approach

How the stationary test works

The test follows the national stationary exhaust noise procedure for in-service vehicles.

  • The car is held at a specified test engine speed, not redline. It's taken from published data for that model.
  • Where no figure exists, EPA Victoria's data manual sets defaults. For cars: 4000rpm for five cylinders or fewer, 3200rpm (pre-1995) or 3600rpm (1995 on) for sixes, 3300rpm (pre-2000) or 3900rpm (2000 on) for V8s, 4300rpm for more than eight cylinders and 4500rpm for rotaries.
  • The microphone sits close to the exhaust outlet, about half a metre away at roughly 45 degrees to the gas flow.

Running a valved exhaust? Don't bank on the quiet setting saving you. Know what the car reads with the valves open at the test rpm, and check with the tester how they'll handle it.

What the states do about it

StateWho enforcesWhat happens
NSWPolice, NSW EPADefect notice, possible test at an EPA-approved station, fines. EPA can suspend rego if a noise defect isn't fixed.
VICPolice, EPA VictoriaEPA notices are separate from VicRoads defects. Clear them at an EPA-approved noise tester and lodge the certificate with the EPA.
QLDPoliceLimits set by the Vehicle Standards and Safety Regulation, aligned to ADR 83/00 with a 5 dB tolerance.
Other statesPolice, state EPA or transport authorityNational limits apply. Check local enforcement with the state authority.

NSW penalties

NSW's noise regulation was replaced on 28 August 2026, and the EPA says the new regulation brings higher penalties for vehicle noise. Under the previous scheme, fines were tiered by how far over the limit you were, with the top tier at 15 dB(A) or more over. Separate offences cover tampering with noise control equipment and selling a car that's over the limit. Check the current amounts with the NSW EPA.

Victoria

VicRoads can't clear an EPA notice. You present the car where the notice says, get it tested by an EPA-approved noise tester and lodge the Certificate of Compliance with the EPA.

Exhausts, cats and emissions

Noise isn't the only exhaust rule. Victoria's VSI 8 requires that exhaust gas can't enter the cabin, no part passes through the passenger compartment, and original catalytic converters, sensors and particulate filters stay in place and working. NSW's VSI 06 says alternative exhausts that keep the original or equivalent emission control equipment, like headers, mufflers or full systems, don't need certification. Pulling the cat is a different story.

In Victoria, extractors are allowed without certification on vehicles made before July 1976. Later cars need an approval certificate or acceptable manufacturer evidence.

Swapping engines? Noise compliance is part of the engineering sign-off. See our LS swap guide.

  • Look up your limit before you buy an exhaust, not after.
  • Ask the exhaust maker whether they have noise test data for your model at its test rpm.
  • If it's borderline, have it tested before police do. An exhaust shop with a calibrated meter can tell you where you sit.
  • Keep the cats and the paperwork for any high-flow replacements.

Already got a notice? Here's how to clear a defect.

Limits, tolerances and fines can change. Confirm with your state EPA or a licensed tester before you fit anything.

Sources

Frequently asked questions

What is the legal exhaust noise limit for a car in Australia?

It depends on build date. Older cars have a stationary limit of 96 dB(A), cars from the early 1980s on are 90 dB(A), and cars certified to ADR 83/00 must stay within 5 dB(A) of their published stationary noise level. NSW and Victoria use slightly different cut-off dates for the 96 to 90 changeover.

How do I find my car's ADR 83 stationary noise level?

Look up the car on the federal Green Vehicle Guide, which lists stationary 'signature' noise for light four-wheeled vehicles. Vehicles not listed are covered by a supplementary federal spreadsheet.

Is a cat-back exhaust legal in Australia?

It can be, as long as it keeps the original or equivalent emission control equipment and the car stays within its noise limit. NSW lists alternative exhausts that retain emission controls as not needing certification. Removing the catalytic converter is not legal.

What happens if my car is too loud?

Police or the EPA can issue a defect notice or require the car to be tested at an approved noise testing station. In NSW, the EPA can suspend the car's rego if a noise defect isn't fixed.

What RPM is the exhaust noise test done at?

At a set test engine speed published for that vehicle, not redline. Victoria's EPA data manual lists defaults where no figure exists, such as 3900rpm for an eight-cylinder built from 2000.

Related guides