In this guide
The LS1 turned the Commodore SS from a good V8 sedan into a proper performance car. An aluminium Gen III V8 from the Corvette family, six-speed manual available, independent rear end, and a chassis that rewards a bit of work. Twenty-odd years on, these cars are the entry point to V8 Holden ownership and a favourite base for builds.
Plenty have been flogged, tuned or both. Buy carefully and you get one of the best-value V8s in the country.
Quick answer: LS1 Commodores span the VT Series II (1999) to the VZ (2006), with the SS rising from 220 kW to 250 kW, and the MY06 VZ getting a 6.0-litre at 260 kW. Check for oil burning, cold-start piston rattle, rear main seal and sump leaks, and do a compression test. The 4L60E auto is the weak link once power goes up. Watch rear tyre wear on VT and VX Series I cars.
LS1 Commodore model history
The VT launched in 1997 with Holden's own 5.0-litre V8. The LS1 replaced it with the VT Series II in 1999 and stayed until the VZ.
| Model | Years | Engine | SS output | Transmissions |
|---|---|---|---|---|
| VT Series II SS | 1999–2000 | 5.7L LS1 V8 | 220 kW | 6-speed manual, 4-speed auto |
| VX SS (Series I and II) | 2000–02 | 5.7L LS1 V8 | 225 kW | 6-speed manual, 4-speed auto |
| VY Series I SS | 2002–03 | 5.7L LS1 V8 | 235 kW | 6-speed manual, 4-speed auto |
| VY Series II SS | 2003–04 | 5.7L LS1 V8 | 245 kW | 6-speed manual, 4-speed auto |
| VZ SS | 2004–06 | 5.7L LS1 V8 | 250 kW / 470 Nm | 6-speed T56 manual, 4-speed auto |
| VZ SS (MY06) | 2006 | 6.0L L76 V8 | 260 kW / 510 Nm | 6-speed manual, 4-speed auto |
The manual is a Tremec T56 six-speed and the auto is the GM 4L60E four-speed.
Changes worth knowing
- VX: Small power increase from the tune alone. Traction control was added on manuals. The VX Series II added a rear toe-control link and revised bushes, which improved handling and cut rear tyre wear.
- VY: New styling, new dash and body kit. A limited-run SS wagon with 17-inch wheels and FE2 suspension. The SV8 gave a V8 option below the SS.
- VZ: Light facelift, shorter 3.73 final drive on manuals for better launches, and a revised torque converter and shift control on autos. The SS wagon was dropped.
- MY06 VZ SS: The 6.0-litre L76, without AFM, brought more low-down torque. Short production run, so these are less common.
What goes wrong
Oil consumption and piston rattle
Early LS1s are known for cold-start piston rattle, put down to piston design and materials. It's not usually considered harmful long term. Oil burning is the bigger worry, and some engines did both. Holden's supplier improved build quality and crankcase ventilation through later VX and early VY production.
Oil starvation
Some engines were damaged after running low on oil between services, often on cars that were also burning it. Ask how often the owner tops up.
Leaks
Sump bolts can loosen and leak. Rear main seals fail occasionally, and the fix means pulling the gearbox, so it's a bigger job than it looks.
Rebuilt engines
Engines that were repaired or replaced under warranty may carry an "X" stamped before the engine number. Not a problem in itself, but it tells you the engine has a history worth asking about.
4L60E auto
Fine in a stock, serviced car. Behind a cammed or boosted LS1 it's the first thing to go. Flare between gears, late or slurred shifts and slipping on hard throttle are bad signs.
Rear end and tyre wear
VT and VX Series I cars can chew rear tyres, especially if they've towed or carried heavy loads. The VX Series II toe link largely fixed it. Bald rears and odd wear patterns can also mean worn IRS bushes or a hard life.
General age
Expect tired suspension bushes, worn shocks, cracked or faded interior plastics and electrical gremlins on cars this age. None are deal-breakers, but they add up.
LS1 Commodore inspection checklist
- Cold start: Listen for piston rattle and lifter noise, and watch for blue smoke.
- Oil: Check level and condition. Ask how much oil it uses between services.
- Compression or leak-down test: Worth doing on every LS1. A pre-purchase inspection will cover it.
- Underneath: Look for oil at the sump and between engine and gearbox (rear main seal).
- Engine number: Look for an "X" prefix and ask about history.
- Auto: Firm, clean shifts with no flare. Check fluid colour and smell.
- Manual: Clean shifts through all six gears, no crunching, no clutch slip under load.
- Rear tyres: Uneven wear or mismatched tyres front to rear.
- Steering and front end: Clunks over bumps, play in the steering, uneven front tyre wear.
- Red flags: Drift stickers, bald rears and odd front-end geometry suggest a hard life.
- Paperwork: Service history, receipts and a PPSR check.
Modified LS1 Commodores: what to look for
The LS1 responds well to tuning and has a huge aftermarket. Typical steps are exhaust and tune, then a cam and valve springs, then heads, intake or forced induction.
Look for:
- A cam with matching springs. A big cam on stock springs is asking for trouble. Ask for the part numbers.
- Tuner details. Who tuned it, what fuel, what power. Our dyno tuning guide explains what to expect.
- Driveline to match. A modified auto should have a rebuilt or upgraded 4L60E or a swapped transmission, with receipts. Manual cars should have a clutch rated for the torque.
- Blown and turbo builds. Fuel system, cooling, tune and driveline all need to keep up. Our guide on the cost to turbo an LS explains what a proper setup involves.
- Engineering. Big engine changes and lowered suspension may need certification depending on your state. See what mods need engineering and lowered car laws.
An unmodified, serviced car is often the safest buy if you plan to build it your way.
What drives LS1 Commodore value
We don't quote prices. The market moves and condition varies too much. What moves the number:
- Model and series. VY Series II and VZ cars generally ask more than VT and VX. The MY06 6.0-litre VZ has its own following.
- Transmission. Manuals attract stronger interest.
- Body style and rarity. The limited VY SS wagon and special editions draw collectors.
- Originality and kilometres. Clean, unmodified, low-kilometre cars are getting harder to find.
- Engine health. Documented compression results and oil consumption history give buyers confidence.
- Build quality on modified cars. Receipts, tuner details and engineering paperwork hold value. Mystery builds don't.
Read our guides on whether mods add value or kill it and how to tell a genuine build from a cheap one.
LS1 Commodores for sale
Browse live Commodore listings below, or search all Holden Commodore listings.
Planning a build? Find tuning or dyno workshops near you.
Related guides
- Holden VE/VF SS Commodore Buyer's Guide
- Holden VL Turbo Buyer's Guide
- LS Swaps: How to Make an Engine Swap Legal in Australia
- Buying a Modified Car: 15 Things to Check Before You Pay
List your car free. Never expires.
List your carFrequently asked questions
Which Commodores have the LS1?
The 5.7-litre LS1 was fitted to V8 Commodores from the VT Series II in 1999 through the VX, VY and VZ. Late VZ models moved to the 6.0-litre L76.
How much power does an LS1 Commodore make?
The SS made 220 kW in the VT Series II, 225 kW in the VX, 235 kW in the VY Series I, 245 kW in the VY Series II and 250 kW in the VZ. The MY06 VZ SS with the 6.0-litre L76 made 260 kW.
Is the LS1 piston slap a problem?
A cold-start rattle from piston design is common on early LS1s and is not usually considered harmful long term. Oil burning is the more serious concern, so check consumption and do a compression test.
Is the 4L60E auto reliable in an LS1 Commodore?
It's fine in a stock car that's been serviced, but it's the weakest part of the driveline once power goes up. Modified autos should have a rebuilt or upgraded box with receipts.
Which LS1 Commodore is the best buy?
Later VY Series II and VZ SS models have the most power and the most refinement. The VX Series II added a rear toe-control link that improved handling and reduced rear tyre wear.




